Wholesale Blue Wildcat Engraved Leatherette Hat Patch - MR01

Explore our fierce Wildcat hat patch, perfect for sports enthusiasts! This striking patch is a bold statement piece that enhances any cap. Distinctive patches like the Blue Wildcat give your hat bar character — they tell customers that your selection goes beyond the basics and rewards browsing. These designs attract gift-seekers and individuals looking for something genuinely one-of-a-kind. The Blue Wildcat adds variety and discovery appeal to a hat bar — it's the design that customers who've seen everything else finally gravitate toward. Unique patches like this serve the shopper who wants to stand out rather than blend in. Engraved on Lonestar Adhesive's Premium Rawhide Leatherette with Durabull Adhesive. Stock your hat bar with all of our premade patches! Search "MR01" on this site to find everything that we (Ink and Ember) offer for a flat $5 shipping (the more patches you buy, the more profitable your hat bar is!) These patches are engraved on leather to give a clean and unique image on the leatherette which is then laser cut precisely around the image and are great for hats, backpacks and anything you can imagine. Hat not included. Patches are sized to standard sizes for hats (approximately 2" - 2.5" tall or wide) - if you need specific sizing on a patch, pleaes message us before purchasing. Leatherette is a vegan leather with heat activated adhesive already on the back. APPLICATION INSTRUCTIONS : * Preheat hat in hat press for 30 seconds at 325°F with thin silicone sheet between the hat and platen * While heating hat, heat the back of the patch with a heat gun on low for 15 to 30 seconds until you see the adhesive change and the patch may begin to curl (reflective, more tacky) (note: it's a heat gun not a blow drier). This shows that the print has become more pliable and ready to attach to the hat. * When 30 seconds is over remove the hat press heater and silicone pad from the hat and apply the patch to the hat in desired location, careful it's hot. * Press again for 30 seconds with light to medium pressure with a silicone pad on top of the patch and hat. Check edges of the patch and make sure it stuck, if not adhered on the edges, repress the hat until you get desired results.