Wholesale 10x4 Steel Black Floor Register - 2-Way Airflow (Duct Opening)

⚠️ CHECK SIZE BEFORE PURCHASE: Fits a 10" × 4" duct opening (measure the hole, not the old cover). Please check the Sizing Guide below for overall dimensions. * Drop-in floor replacement for any 4” × 10” floor duct opening — no remodeling required. * Solid steel construction — heavy-gauge, walkable, and built for normal residential foot traffic. * 2-way airflow design — dual-deflector surface spreads conditioned air in both directions simultaneously. * All-steel lever damper — open, close, or partially restrict airflow with a simple lever. No plastic to warp. * Built-in mesh insert keeps coins, crumbs, and small debris out of your ductwork. * Matte Black powder-coated finish — hides scuffs and surface wear better than glossy finishes. * Single Pack — The single pack is ideal when you need to replace one worn, rusty, or mismatched 4x10 floor register in a kitchen, hallway, bedroom, entryway, or home office. Built tough for traditional and high-traffic floors Replace your dated 4” × 10” floor vent with a solid steel register built for rooms that see daily use. This 4x10 matte black floor register drops directly into your existing floor opening — no remodeling, no subfloor modification required. The dual-deflector surface spreads conditioned air across a wider floor area in both directions at once, helping reduce hot and cold spots compared with single-direction registers. The all-steel lever damper lets you open, close, or partially restrict airflow in any room — useful for spaces that run too warm, too cold, or sit unused for part of the season. Finished in matte black powder coat, it sits flush on hardwood, distressed wood, LVP, stained concrete, and light oak floors where contrast is intentional. Built for single-room floor vent replacement The single pack is ideal when you need to replace one worn, rusty, or mismatched 4x10 floor register in a kitchen, hallway, bedroom, entryway, or home office. The same solid steel frame, built-in mesh insert, and 2-way airflow face are used across the pack configuration, so each room gets a consistent look and feel. This is especially useful for landlords, remodelers, and homeowners replacing multiple old registers during one project. Designed for the rooms steel still owns Aluminum registers work well in many modern spaces, but kitchens, hallways, dining rooms, and entryways still call for steel. This 4x10 steel floor register is built from powder-coated steel and designed to drop into any 4” × 10” floor opening without tools.